Technical parameter of equipment
Driving mode:hydraulic drivenSqueezing direction:For cylindrical batteries, the longitudinal axis of piercing the battery shouldbe parallel to the two plate of the extrusion device
As for square and soft battery, pierce the battery only at the center section of the wide side.
As for the coin type or button type battery,pierce in a way that the upper and lower planes
of the battery are parallel with the plate.
| Sample number |
One sample |
| Maximum pressure range |
1 kN ~20kN |
| Unit conversion |
kg, N, lb |
| Effective test space |
500*500*500mm(L*W*H) |
| Needle stroke |
500mm |
| Delay function |
0-9999 (H/M/S could be set arbitrarily and adjust test time) |
| Clamping method |
manual clamping |
| Machine size |
1400*800*1900mm(W*H*L) |
| Power supply |
AC380V, 50~60HZ, 10A |
| Power |
3.8KW |
| Weight |
about 300kg |
Design specification for main components of equipment:
Control scheme :control the sensors, provide with closed loop response
travel switch, interpret the sensor output signal
Sensor:calculate the needle stroke and linear speed by pulse signal
Hydraulic pressure station :provides stable pressure and power source with variable speed .High
power motor and domestic high quality pump provide with stable output. Overflow valve ,
solenoid valve and pressure release valve provide with variable-speed power
Mechanical section:chromium plated high performance high carbon steel constitute two
main sections of the transmission support, the test trip: 500mm ;
Safety protection system
1,Overvoltage protection :the sensor has a built-in pressure range, which can prevent the damage
to the sensor effectively and the drive motor due to excessive pressure
2,Phase loss and anti-phase protection switch
3,Travel limit protection
4,Circuit fuse overcurrent protection
5,Overload protection
Service condition:
1,Ambient temperature :25±5℃
2,Power supply condition:Three-phase four wire electric source
Basic subassembly list:
| Name |
Specification or brand |
Producing area |
| Hydraulic pressure system |
Shanghai Sanzhen |
Shanghai |
| Control board |
Independent R&D |
Dongguan |
Equipment configuration list:
1,Test host : 1 set
2,Standard extrusion plate: 2 set
3,Factory certificate : 1 piece
4,product specification: 1 piece
